ASTM C1090 PDF

Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Mull Shakakree
Country: Vietnam
Language: English (Spanish)
Genre: Video
Published (Last): 24 March 2017
Pages: 313
PDF File Size: 1.19 Mb
ePub File Size: 17.17 Mb
ISBN: 189-8-97727-593-3
Downloads: 39807
Price: Free* [*Free Regsitration Required]
Uploader: Faubei

This thickness was then added to the four-reading initial measurement.

ASTM International – Standard References for ASTM C / CM – 15

Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure The glass plate was removed from the top of the test specimen after 24 h.

Combining values from the two systems may result in non-conformance with the standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

An exception is made when astn options described in the section on test conditions are exercised. Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold.

ASTM C Standard

Link to Active This link will always route to the current Active version of the standard. Some values have only SI units because the inch-pound atm are not used in practice. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

These test methods cover procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s For cementitious grouts, saturate the surface up to SSD. The alternative designation given in parentheses is for information only and does not asym a different standard sieve size. The degree of restraint varies with the mixture viscosity and degree of hardening.

Sieve size is identified by its standard designation in Specification E I married on 30 th June now having one b The laser approach has been compared with the original setup, and satm results were obtained. Historical Version s – view previous versions of standard.

ASTM C1090

The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height. The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C In both test methods, there is always a certain degree of friction asm the specimen’s sides and the inner surface of the metallic mold.

After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

Testing of shrinkage for concrete – grout. Newer Post Older Post Home. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.